Upgrade 20x20mm XJB V2 PBF3 EVO Flight Control AIO PDB BEC D-shot & 25A Blheli_S 2-6S 4 in 1 ESC
Specification:
Item Name: PBF3 EVO Flight Control Board AIO PDB BEC & 25A 4 in 1 ESC Fly Tower
Model: XJB V2
Weight: 6.5g
Usage: for 65mm-250mm Frame Kit
6Dof PBF3 EVO Flight Control Board ( D-Shot Version):
MPU: MPU6000
CPU: STM32F3CCT6, Flash 256K.
Input Voltage: 2-6S Lipo
BEC Output: 5V@3AInput Voltage: 2-6S Lipo
Size: 23x23mm board, 20mm mounting holes (M2)
Weight:2.3g
Firmware: BF3.15 Firmware
Firmware: BF3.15 Firmware
Built-in RC/LC filter
Support Subs/PPM/DSMX receiver
-6Dof version, without Barometer and Compass
25A 2-4S Blheli_S 4 in 1 ESC:
Package Included:
-6Dof version, without Barometer and Compass
25A 2-4S Blheli_S 4 in 1 ESC:
Input Voltage: 2-4S Lipo battery
Constant Current: 25A
Peak Current: 30A (10S)
BEC Ouput: NO
Firmware: BLheli_S 16.5
Size: 27x27mm (main board)
31x31mm ( including pad)
31x31mm ( including pad)
Weight: 4.2g
CPU: SILABS EFM8BB2 48MHZ
MOS Tube: TOP QUALITY MOSFET
Support Damped Mode, Oneshot125, multishot, Dshot150, Dshot300, Dshot600, forward and reverse
Note:
This FPF3 EVO Flight Control Board is D-Shot Version. It was flashed BF3.15 firmare and set CLI Order of replacing S1-S4; S4-S6.
So, if you want to flash the latest BF Firmware, you just need input the following Order to the CLI Order Site in BF Ground. Then, save and reset.
Same firmware, don't need reset.
Note:
This FPF3 EVO Flight Control Board is D-Shot Version. It was flashed BF3.15 firmare and set CLI Order of replacing S1-S4; S4-S6.
So, if you want to flash the latest BF Firmware, you just need input the following Order to the CLI Order Site in BF Ground. Then, save and reset.
Same firmware, don't need reset.
resource MOTOR 5 none
resource MOTOR 6 none
resource MOTOR 1 A01
resource MOTOR 4 A02
save
Package Included:
1x PBF3 EVO 6Dof Flight Control Board AIO PDB BEC
1x 25A Blheli_S 4 in 1 ESC
Advertising