Main Features:
Built-in eight RGB LEDs and an MCU
Dual modes: MCU control and CleanFlight control
MCU mode: 7 colors ( white, green, red, blue, yellow, cyan, and magenta ), 4 statuses ( Constant Light, Slow Flash, Fast Flash, Violent Flash )
CF mode: compatible with flight controllers with CleanFlight firmware, such as CC3D, Naze32, SP Racing F3 and etc.

Specifications:
Operating voltage: 4.5 - 5.2V DC
Power of MCU mode ( 5V input ):
White: 1.8W / 0.36A
Green / Red / Blue: 0.6W / 0.12A
Yellow / Cyan / Magenta: 1.2W / 0.24A
Mounting holes: 2.6mm in diameter, 30mm square spacing
Size: 65 x 10mm
Weight: 2.71g

How to use:
1. Connect the 5V pin and GND of the LED board to a 5V power source.
2. Press the button to choose among white, green, red, blue, yellow, cyan, and magenta.
3. Hold the button for 2s to enter the LED mode settings, and press the button to configure: MCU mode ( 1st LED: Constant Light, Slow Flash, Fast Flash, Violent Flash ); CF mode ( 1st LED: Off ).
4. The mode will be saved if there is no action within 5 seconds.
5. If MCU mode is chosen and saved, the color can be changed by pressing the button.
6. If CF mode is chosen and saved, please connect the DIN to your flight controller.
CC3D: Pin Motor - 5
Naze32: RC5 pad
SP Racing F3: LED Strip pad
Please set the LED status in GUI according to the CleanFlight guide.
Click here to download the instructional video.

Product Safety Disclaimer:
We do not accept any responsibility or liability for misuse of this or any other product. All our products are extensively tested to comply with rigorous and strict QC standards. For certain products (e.g. toys, knives, etc.), we recommend proper supervision as we cannot be held liable for misuse or accidents.

Small Parts Disclaimer:
These toys contain small parts, not for children under 3 years in case of swallowing or choking . We do not accept any responsibility or liability for misuse of this or any other product.