Introduction:
Cooltec 2.4GHz Spread Spectrum FASST Compatible Receiver is designed to use with FUTABA FASST 2.4GHz Air System
(7CH Mode/Multi Molde), such as TM7, TM8, TM10, TM14 or T6EX-2.4G, 7C-2.4G, 8FG, 10CG, 12FG , 14MZ, 14SG, 18MZ.
Specification:
Brand name: cooltech
Item name: RFA16 2.4GHz receiver
Operating Voltage Range: 3.5~8.4V
Dimension: 46.7X14.6X36.8mm
Weight: 17g
Latency: 14ms(LS)
:7ms(HS)
Sensitivity: about -96dBm
Binding procedure:
Binding procedure:
Turn on the transmitter, get to the LINKAGE MENU - SYSTEM and select FASST-7CH or FASST- MULT, Connect
battery to the receiver while holding the F/S button on the receiver, the red LED on the receiger is off and green
LED constant on indicates binding successfully.
Setting failsafe:
LED constant on indicates binding successfully.
Setting failsafe:
RFA16 support two delectable failsafe setting options, either use native failsafe position preset on transmitter, or set failsafe on RFA16.
1) Use native failsafe position preset on the transmitter side:
If not disabling failsafe on the transmitter side, RFA16 will use native failsafe position preset on the transmitter side.
2) Set failsafe on RFA16:
RFA16 supports failsafe function for all trannels. Follow the steps below to set failsafe positions for each channel.
(1) Bind the receiver first and disable failsafe on the transmitter side;
(2) Set all transmitter controls to the desired failsafe position;
(3) Press briefly the F/S button on the receiver(less than 1 second), the green LED will flash twice, indicating the failsafe is set up successfully;
(4) To disable the failsafe fuction, just need to rebind the receiver.
How to switch between LS and HS modes:
Turn the transmitter off, connect the battery to the receiver, press the F/S button of receiver for 6 seconds and then release.
The red LED will flash fast in HS mode and slow in LS mode. Reapeat this to alternate modes.
Package included:
1x RFA16 2.4GHz receiver
How to switch between LS and HS modes:
Turn the transmitter off, connect the battery to the receiver, press the F/S button of receiver for 6 seconds and then release.
The red LED will flash fast in HS mode and slow in LS mode. Reapeat this to alternate modes.
Package included:
1x RFA16 2.4GHz receiver
Advertising