APM Current&Voltage Sensors For APM2.5/2.6/2.8 PX4 Flight Control 3 In 1

Description:
Item Name:APM Current&Voltage Sensors
Voltage Input:2S-6S
Voltage Sampling: 10/1
Output sub-line: 6-way
BEC Output: 5.3V / 3A (PWM switching)
Installation pitch: 45mm x 45mm
External dimensions: 50mm x 50mm
Usage:for APM2.5/APM2.6/APM2.8/PX4 Flight Control

Features:
Integration of galvanometer,UBEC,sub panels as a function of APM current&voltage sensors
Compatible with APM2.5/APM2.6/APM2.8/PX4 Flight Control
PCB using double-sided 3 times copper immersion gold process,excessive current is stable and reliable
The onboard 5.3V / 3A switching power supply UBEC
Current and voltage sampling circuit compatible 3DR galvanometer, without calibration, you can connect flight control and simple settings then it can be used

Using methods:
Board marked B +, B- is to connect the battery input terminal,the output terminal is six pairs of pads arranged side by side,respectively + - as a standard for welding ESC power lines.
Make sure that the correct welding.
Galvanometer connect with APM through a 6PIN signal cable,APM terminal please insert labeled PM’s 6 hole socket,and unplug the JP1 jumper cap.
Prevent galvanometer power supply and power transfer in parallel which is not allowed, unless your ESC does not have BEC output.
Special Note: Compatible with standard version APM,please pay attention to the line sequence of APM and distributor wiring board.
After connecting,set the current&voltage sensors in the following photo in the MP then it can be used.



Package Included:
1 x 3 in 1 galvanometer board
1 x 15cm 14AWG red silicone cord
1 x 15cm 14AWG black silicone cord
1 x XT60 battery connector plug(1 pair)
1 x 6PIN power supply signal line(1 set)
1 x Heat Shrink Tubing(1segment)