How To Flash Blackbox Firmware to OpenLog
This video shows you how to flash the blackbox firmware to your OpenLog device using the Arduino interface.
Before you proceed, wait! You may already have the correct firmware! Put a blank, FAT-formatted SD card into the OpenLog. Power the OpenLog with 5v. Wait ten seconds. Power it down. Then remove the card. A file named CONFIG should be on the card. If the file contains only the "baud" parameter, you are good to go.
Some OpenLog devices purchased from Amazon or eBay or Banggood do not work with the Arduino software. If you cannot get the board to flash, you may have this problem. The simplest thing to do if you are in the United States is to order an OpenLog device from MultirotorMania.com. Their devices so far have always shipped with the correct firmware already installed.
Before you proceed, wait! You may already have the correct firmware! Put a blank, FAT-formatted SD card into the OpenLog. Power the OpenLog with 5v. Wait ten seconds. Power it down. Then remove the card. A file named CONFIG should be on the card. If the file contains only the "baud" parameter, you are good to go.
Some OpenLog devices purchased from Amazon or eBay or Banggood do not work with the Arduino software. If you cannot get the board to flash, you may have this problem. The simplest thing to do if you are in the United States is to order an OpenLog device from MultirotorMania.com. Their devices so far have always shipped with the correct firmware already installed.
Rcreviews.lt is not the owner of this text/video/image/photo content, the real source of content is Youtube.com and user declared in this page publication as Youtube.com user,
if you have any question about video removal, what was shared by open community, please contact Youtube.com directly or report bad/not working video links directly to video owner on Youtube.com. Removed video from Youtube.com will also be removed from here.
Advertising