A problem with my HobbyKing Pulsejet
Unfortunately, there seems to be a problem with the "flowjector" on my HobbyKing pulsejet.
Instead of directing the spray of air and fuel down the inlet tubes, past the valves and into the combustion chamber, the angles are such that the fuel hits the venturi then runs out the front of the engine.
Despite having plenty of air pressure, fresh fuel and a good spark, the engine barely managed a couple of very weak pops and when I removed the valve-head it was still bone-dry inside.
I will investigate further and probably make up my own flowjector with better geometry before trying again.
I see that NightFlyyer has a similar problem attempting to get his engine to run in this video:
Stay tuned, the engine will be running shortly.
Instead of directing the spray of air and fuel down the inlet tubes, past the valves and into the combustion chamber, the angles are such that the fuel hits the venturi then runs out the front of the engine.
Despite having plenty of air pressure, fresh fuel and a good spark, the engine barely managed a couple of very weak pops and when I removed the valve-head it was still bone-dry inside.
I will investigate further and probably make up my own flowjector with better geometry before trying again.
I see that NightFlyyer has a similar problem attempting to get his engine to run in this video:
Stay tuned, the engine will be running shortly.
Rcreviews.lt is not the owner of this text/video/image/photo content, the real source of content is Youtube.com and user declared in this page publication as Youtube.com user,
if you have any question about video removal, what was shared by open community, please contact Youtube.com directly or report bad/not working video links directly to video owner on Youtube.com. Removed video from Youtube.com will also be removed from here.
Advertising