Tom's 3D-Printed BIKE~
Follow-up Q&A video:
_________________________________________________________________
DIY Electric Bike - Parts list
3D print designs:
WREN'S 3D PRINTER~
The VESC (Speed controller) - /
VESC setup links:
Bike:
Motor:
Saddle Bag (for battery):
Throttle Handlebar:
Batteries: 6 cell (6s=22.2V) 10,000mAh: this will deliver ABOUT 10 miles of range or less.
Freewheel Cog:
Seatpost Suspension:
Nuts/screws/belts/pulley needed:
HTD5 12T pulley (with 8mm bore for motor shaft):
(Will need to bore out hole from 6mm to 8mm)
HTD5 800x15mm belt:
Bearings:
We can get these from a hardware store, otherwise you’re getting sets of 30pcs off Amazon
5pcs m4x30mm bolts (clamp motor mount to frame)
4pcs m4x10mm bolts (attach motor to mount)
1pcs m4x50mm bolt (roller bearings seat on this bolt)
5pcs m4 nyloc nuts
3pcs m3x10mm bolts (assembly of electronics case)
5mm wide cable ties (attach pulley to spokes)
_________________________________________________________________
The following should be purchased after looking at the electronics in person
EC5 battery connectors
4mm bullet connectors (for ESC)
_________________________________________________________________
CONSIDER SUBSCRIBING ►
Watch This Show From The Beginning ► ...
This Episode ► Wren uses a Tesla battery to build an electric bike so his wife can ride with him.
THE GEAR WE USE ►
Most Used Equipment:
Perfect Camera:
Puget Systems Computers:
SUPPORT US ►
Translate & Subtitle:
Patreon Donation:
Buy Merch:
FOLLOW US ►
Instagram:
Sub-Reddit:
MUSIC BY ►
Ginger Runner "Carpet Ride"
Prince Mathicks "my name"
JHFLY "we blessed"
FILM RIOT "Cinema Pack" & "Horror Pack"