(9/9) CC3D Flight Controller – Setup for a Tricopter
To see all of the videos in this series visit
You can see me building this frame in this video –
You can order the same frame here -
You can see more about the little FPV transmitter used here in this video -
In this video configure the great little CC3D board in another type of multirotor frame - a Tricopter!
In this video we cover –
- Introduction (0:02)
- How to wire up the Tri-copter (2:39)
- How to install the firmware using the Wizard (3:48)
- How to check the settings are right in GCS (11:20)
- How to test the tail moves in the right direction (12:44)
- How I fixed the tail jitter problem on this model (13:58)
- Summary (18:25)
Thank you for watching, please LIKE and SUBSCRIBE.
Happy flying!
You can see me building this frame in this video –
You can order the same frame here -
You can see more about the little FPV transmitter used here in this video -
In this video configure the great little CC3D board in another type of multirotor frame - a Tricopter!
In this video we cover –
- Introduction (0:02)
- How to wire up the Tri-copter (2:39)
- How to install the firmware using the Wizard (3:48)
- How to check the settings are right in GCS (11:20)
- How to test the tail moves in the right direction (12:44)
- How I fixed the tail jitter problem on this model (13:58)
- Summary (18:25)
Thank you for watching, please LIKE and SUBSCRIBE.
Happy flying!
Rcreviews.lt is not the owner of this text/video/image/photo content, the real source of content is Youtube.com and user declared in this page publication as Youtube.com user,
if you have any question about video removal, what was shared by open community, please contact Youtube.com directly or report bad/not working video links directly to video owner on Youtube.com. Removed video from Youtube.com will also be removed from here.
Advertising