Ask This Old House general contractor Tom Silva explains the proper use of a drill/driver. (See below for tools and steps.)
SUBSCRIBE to This Old House:
Tools for How to Select and Use a Drill/Driver:
- Impact driver
- Drill/driver
Steps for How to Select and Use a Drill/Driver:
1. To lock the drill bit into place on a drill/driver, place it into the keyless chuck and slowly press the trigger, then twist the chuck to lock it into place.
2. To make sure you’re on the drilling setting, there should be a twistable feature on the top of the drill/driver with a picture of a drill bit. For driving, there’s a picture of a screw. And some drill/drivers also have a picture of a hammer, for use as a hammer drill into masonry.
3. Drill/drivers come with a clutch setting. The numbers are next to the chuck and can be adjusted to suit the project. For fine work, keep the clutch setting low. For more power, the clutch setting can be higher.
4. There’s a setting for torque on the very top of the drill/driver. One setting can be used for speed; the other can be used for power.
5. The trigger on the drill/driver can also vary the speed.
6. Next to the trigger is a back-and-forth button that sets the drill for forward and reverse.
About Ask This Old House TV:
Homeowners have a virtual truckload of questions for us on smaller projects, and we're ready to answer. Ask This Old House solves the steady stream of home improvement problems faced by our viewers—and we make house calls! Ask This Old House features some familiar faces from This Old House, including Kevin O'Connor, general contractor Tom Silva, plumbing and heating expert Richard Trethewey, and landscape contractor Roger Cook.
Follow This Old House and Ask This Old House:
Facebook:
Twitter:
Pinterest:
Instagram:
Tumblr:
For more on This Old House and Ask This Old House, visit us at:
How to Select and Use a Drill/Driver | Ask This Old House
/